Shop Antique Radio Knobs
Shop Antique Radio Knobs

Knobs Guide

Antique Radio Knobs

A missing or mismatched knob is the most common thing wrong with an old radio, and the easiest to fix once you know what you're looking for. This guide shows how to match a knob to your radio's shaft, how to get a stuck knob off and clean it up, and where to find original and reproduction knobs today.

Reader-supported: we may earn a commission when you buy through links on this page.

Radio Knobs At A Glance

Each row links to current listings. Original knobs from the radio's own maker look right; reproductions cost less and are easier to match in sets.

Philco Radio Knobs

1930s–1950s · Bakelite, set screw and push-on

$12–$30 each typical

Zenith Radio Knobs

1930s–1950s · Bakelite, wood and plastic

$19–$50 each typical

RCA Victor Radio Knobs

1930s–1950s · Bakelite and plastic

$14–$35 each typical

Bakelite Radio Knobs, Any Brand

1930s–1950s · Brown and black Bakelite

$10–$20 each typical

Knob Lots And Sets

Mixed · Mixed brands and styles

$16–$40 per lot typical

Reproduction Knobs

New · Cast resin, wood or 3D printed

About $12–$16 each typical

Start With The Shaft

Before you shop for a knob, pull one off (or look at the bare shaft) and check its shape. The shaft decides how the knob holds on, and it's the most common reason a "correct-looking" knob won't fit.

Shaft type What it looks like Knob it takes
Round, solid Smooth round shaft Knob with a set screw that tightens against the shaft
D or "half-moon" Round shaft with one flat side Push-on knob with a D-shaped spring clip inside
Splined or knurled Fine ribs around the end Push-on plastic knob, common from the late 1940s on
Split Shaft slotted down the middle Push-on knob that grips by friction

Most antique radio shafts are 1/4 inch in diameter. The usual exceptions are dual concentric controls (a small knob stacked on a larger one), two-speed tuning shafts and a few small knobs. Some 1940 Zenith consoles, for example, use a small knob on a 1/8 inch shaft.

Tuning knobs on two-speed dials usually need a set screw rather than a push-on fit, because it takes some force to shift the dial between speeds. A push-on knob there tends to pull off in your hand.

Match The Brand And Era

Once you know the shaft, match the look. Most makers used a handful of knob styles per year, so knobs from the same brand and year are usually the right fit.

  • Philco used Bakelite knobs with molded rosette and hex designs on its 1930s cathedrals and tombstones, then simpler push-on knobs on later table radios. See our Philco radio knobs guide.
  • Zenith used everything from turned-wood "pinch" knobs to Bakelite and ivory plastic, and many carry a "Z" logo. See our Zenith radio knobs guide.
  • Bakelite and Catalin sets often have knobs that match the cabinet color, so a single replacement can be hard to match. A full matching set is often the better buy.

The fastest way to confirm what belongs on your radio is to find photos of the same model in an original, untouched example. RadioMuseum.org and Radio Attic both have large photo archives sorted by brand and model number.

How To Remove And Clean Old Knobs

  1. Look for a set screw. Check the side or face of the knob. Loosen it with a small flat or hex driver before you pull.
  2. Pull straight out. For push-on knobs, slide a strip of cloth or a shoelace behind the knob, wrap it around and pull evenly. Don't pry against the cabinet.
  3. Clean gently. Wash Bakelite and plastic knobs in warm water with a little dish soap and a soft brush. Skip harsh solvents, which can dull the finish or lift painted inlays.
  4. Polish. A plastic polish brings back the shine on Bakelite. Go easy on knobs with painted or gold-filled markings.
  5. Refit the spring clip. Loose push-on knobs usually just need a new D-shaft spring clip, which cost very little.

What Antique Radio Knobs Sell For

These ranges come from recent eBay sold listings for single knobs, sets and lots.

Knob type Typical sold price Median
Philco radio knobs, single $12–$30 $20
Zenith radio knobs, single $19–$50 $25
RCA Victor radio knobs, single $14–$35 $25
Bakelite radio knobs, any brand $10–$20 $14
Knob lots and sets, mixed $16–$40 $24
Reproduction knobs $12–$16 $13

Knobs for rare radios, Catalin knobs in bright colors and complete original sets for a specific model can sell for much more.

Shop Antique Radio Knobs

Original Or Reproduction?

Original knobs are best for a collector-grade radio, especially if the rest of the set is untouched. For a radio you plan to use or display, a matching set of good reproductions often looks better than mismatched originals, and costs less. Our reproduction radio knobs guide covers who makes them and what to look for.

About Old Time Replications

This site began as AntiqueRadioKnobs.com, the home of Old Time Replications, Larry Bordonaro's reproduction knob and parts business in Van Nuys, California. Larry passed away in 2015. You can see his Old Time Replications parts list and read more about Larry.

More Knob And Parts Guides

Sources

Antique Radio Knob FAQ

How Do I Know Which Knob Fits My Radio?

Look at the shaft first. A round shaft takes a knob with a set screw, a shaft with one flat side (a D or half-moon shaft) takes a push-on knob with a spring clip, and a ribbed or split shaft takes a push-on plastic knob. Then match the brand and era, ideally by checking photos of the same model on RadioMuseum.org or Radio Attic.

What Size Are Antique Radio Knob Shafts?

Most are 1/4 inch in diameter. The main exceptions are dual concentric controls, two-speed tuning shafts and some small knobs, like the 1/8 inch shafts on certain 1940 Zenith consoles.

How Much Are Old Radio Knobs Worth?

Most single Bakelite knobs sell for $10 to $20 on eBay. Brand-specific knobs for Philco, Zenith and RCA Victor sets usually bring $12 to $50 each, and rare or colorful Catalin knobs can bring more.

How Do I Get A Stuck Knob Off An Old Radio?

Check for a set screw first and loosen it. For a push-on knob, slide a strip of cloth behind the knob and pull straight out evenly. Don't pry against the cabinet, which can crack the knob or damage the finish.

Are Reproduction Knobs Worth Buying?

Yes, for a radio you plan to use or display. A matching reproduction set looks better than mismatched originals, and good reproductions cost about $12 to $16 a knob. For a top collector-grade radio, original knobs add more value.

Written by . Prices reviewed November 2026 from recent eBay sold listings. Ranges are typical sale prices, not appraisals.